Seat Ateca Owner's Manual page 118

● Start-Stop system status display
›››
page 208.
● Active cylinder management display
›››
® page 202
(ACT )*
● Signs recognised by the traffic signal de-
›››
page 245
tection system
● Low consumption driving status (ECO)
›››
page 116
›››
● Engine code (MKB)
Distance travelled
The odometer registers the total distance
travelled by the car.
The odometer ( trip ) shows the distance
travelled since the last odometer reset. The
last digit of the trip recorder indicates distan-
ces of 100 metres or one tenths of a mile.
● Briefly press the button
set the trip recorder to 0.
● Keep the button pressed for about 3
4
seconds and the previous value will be dis-
played.
Time
● To set the time, keep the button
pressed for more than 3 seconds to select
4
the hour or minute display.
● To continue setting the time, press the up-
per or lower part of the button
116
ton down to scroll through the numbers
quickly.
● Press the button
setting the time.
The time can also be set on the Easy Connect
system using the
button SETTINGS > Date and time
›››

page 117.
Compass
With the ignition on and the navigation sys-
tem on, the cardinal point corresponding to
the direction of travel of the vehicle is dis-
played on the instrument panel.
Selector lever position
The selected gear is displayed on the side of
the selector lever and on the instrument pan-
›››
Fig. 119 to re-
el display. In positions D and S, and with the
4
Tiptronic, the corresponding gear is also dis-
played.
Recommended gear (manual gearbox)
The recommended gear in order to save fuel
is displayed on the instrument panel while
you are driving
›››
Fig. 119
Second speed display (mph or km/h)
In addition to the speedometer, the speed
can also be displayed in a different unit of
. Hold but-
4
measurement (in miles or in km per hour).
Operation
again in order to finish
4
button and the function

page 33.
›››

page 41.
This option cannot be deactivated in models
destined for countries in which the second
speed must always be visible.
The second speed display can be adjusted in
the Easy Connect system by means of the
button and the function button SETTINGS >
›››

page 33.
Units
Speed warning
When the speed setting is exceeded, this will
be indicated on the instrument panel display.
This is very useful, for example when using
winter tyres that are not designed for driving
at the maximum speed of the vehicle
›››

page 42.
The speed warning settings can be adjusted
in the Easy Connect system by means of the
button and the function button SET-

TINGS > Driver Assistance
›››

page 33.
Start-Stop operating display
Updated information relating to the status is
displayed on the instrument panel
›››
page 208.
Low consumption driving status (ECO)*
Depending on the equipment, when driving,
the " ECO " display appears on the instrument
panel when the vehicle is in low consump-
tion status due to active cylinder manage-
›››
ment (ACT ® )* page 202.
