Seat Ateca Owner's Manual page 147

Daytime running lights
The daytime running lights consist of individ-
ual lights, integrated in the front headlights.
By connecting the daytime running lights,
›››
these lights are switched on 1)
The daytime running lights switch on every
time the ignition is switched on, if the switch
is in positions  or , according to the level
of exterior lighting.
When the light switch is in position , a
light sensor automatically switches dipped
beam on and off (including the control and
instrument lighting) or the daytime running
lights depending on the level of exterior
lighting.
WARNING
● Never drive with daytime lights if the road
is not well lit due to weather or lighting con-
ditions. Daytime lights do not provide
enough light to illuminate the road properly
or be seen by other road users.
● On vehicles with rear lights with bulbs,
when activating the daytime running light
the rear lights are not switched on. A vehicle
which does not have the rear lights on may
not be visible to other drivers in the dark-
ness, in the case of heavy rain or in condi-
tions of poor visibility.
1) On vehicles equipped with rear LED lights, the rear
side light is switched on as well.
Lights and visibility
Turn signal and main beam lever
Read the additional information carefully
›››

page 31
Push the lever all the way down to turn off
.
the corresponding function.
Convenience turn signals
For the one-touch signalling, when the igni-
tion is switched on, move the lever as far as
possible upwards or downwards and release
the lever. The turn signal will flash three
times.
One-touch signalling is activated and deacti-
vated in the Easy Connect system via the
button and the function button SETTINGS >
Lights > One-touch signalling
›››

page 33.
In vehicles that do not have the correspond-
ing menu, this function can be deactivated in
a specialised workshop.
WARNING
Improper or lack of use of the turn signals, or
forgetting to deactivate them can confuse
other road users. This could result in a seri-
ous accident.
Always give warning when you are going to
●
change lane, overtake or when turning, acti-
vating the turn signal in good time.
As soon as you have finished changing
●
lane, overtaking or turning, switch the turn
signal off.
WARNING
Incorrect use of the headlights may cause ac-
cidents and serious injury, as the main beam
may distract or dazzle other drivers.
Note
If the convenience turn signals are operat-
●
ing (three flashes) and the other convenience

turn signals are switched on, the active part
stops flashing and only flashes once in the
new part selected.
● The turn signal only works when the igni-
tion is switched on. The hazard warning
lights also work when the ignition is switch-
ed off.
If a trailer turn signal malfunctions, the
●
control lamp will stop flashing (trailer turn
signals) and the vehicle turn signal will flash
at double speed.
● The main beam headlights can only be
switched on if the dipped beam headlights
are already on.
»
145