Seat Ateca Owner's Manual page 266

or in locations such as the brow of a hill.
–
In order to guarantee good system opera-
●
tion, keep the ultrasound sensors clean, free
of snow or ice, and do not cover them with
adhesives or other objects.
● If you use high-pressure or vapour equip-
ment to clean the ultrasound sensors, apply
it directly only very briefly and always from a
distance of more than 10 cm.
Retrofitting of accessories to the vehicle,
●
such as a bicycle rack, may interfere with the
operation of the Parking Aid.
In order to familiarise yourself with the sys-
●
tem, it is advised that you practice parking in
an area or car park that is free from traffic.
There must be good weather and light condi-
tions.
The volume and tone of the warnings can
●
be modified, in addition to the indications
›››
page 265.
In vehicles without an infotainment system,
●
these parameters can be modified in a SEAT
Official Service or in a specialised workshop.
Please observe information on towing a
●
›››
trailer page 265.
● The display on the Easy Connect screen
shows a slight time delay.
264
Operation
Parking Aid operation
Manual disconnection of Parking Aid display
(the audible sounds remain active)
● Press a button on the main menu of the fac-
tory-assembled infotainment system.
● OR: press the function button.
BACK

Parking Aid connection
● Engage reverse (for manual gears) or set
the selector lever to R (for automatic gears).
Parking Aid disconnection
● Place the selector level in position P, N or D
(for automatic gearboxes) or disengage re-
verse (for manual gearboxes). If you set the
lever to N or D, the system will remain active
for approximately 8 seconds before switching
off, except with Top View Camera*, when it
will be switched off immediately after engag-
ing reverse.
Temporary suppression of sound in Parking
Aid
Press the  function button. If you have the
●
Top View Camera* system installed, you can-
not use the temporary suppression of sound
in Parking Aid.
Switch from reduced to full-screen view if the
rear assist is fitted (Rear View Camera
"RVC")
● Press the car icon in the reduced view.
If necessary, switch to the rear-assist image
(Rear View Camera "RVC")
● Engage reverse gear or turn the selector
lever to position R.
● OR: press the RVC function icon.
Segments of the visual indication
Fig. 228 Parking Aid display on the Easy Con-
nect system screen.
The distance to the obstacles can be estima-
ted with the help of the segments at the rear
of the vehicle.
The optical indication of the segments works
as follows: