Seat Ateca Owner's Manual page 110

Turn signal bulb
1. Raise the bonnet.
›››
2. Move the loop Fig. 107
rection of the arrow and remove the cov-
er.
3. Turn the bulb holder
clockwise and pull.
4. Remove the bulb by pressing on the
bulb holder and turning it anticlockwise
at the same time.
5. Installation involves all of the above
steps in reverse sequence.
108
Front fog light bulb*
in the di-
1
›››
Fig. 108 anti-
3
Fig. 109
Emergencies
Fog light: extracting the grille.
Fog light: remove the bulb holder
Fig. 110
Follow the steps indicated:
›››
Fig. 109
1. Remove the screw
the fog light grille using a screwdriver
and extract the grille.
›››
2. Remove the 3 screws Fig. 109
3. Remove the metal clip situated on the
upper part of the fog light by pulling
away from the vehicle  and extract
3
the fog light.
›››
4. Remove connector Fig. 110
the bulb.
›››
5. Turn the bulb holder Fig. 110
clockwise and pull.
6. Remove the bulb by pressing on the
bulb holder and turning it anticlockwise
at the same time.
7. Installation involves all of the above
steps in reverse sequence.
8. Check that the bulb works properly.
 from
1
2 .
from
1
anti-
2