Seat Ateca Owner's Manual page 44

When the vehicle is at a standstill or when
travelling at very low speeds, the tempera-
ture displayed may be higher than the true
outside temperature as a result of the heat
produced by the engine.
The temperatures measured range from
-40°C to +50°C (-40°F to +122°F).
Engine oil temperature display
Vehicles without multifunction steering
wheel
● Press the rocker switch
the main menu appears. Enter into Driving
. With the button
data
temperature gauge.
Vehicles with multifunction steering wheel
● Enter the submenu Driving data and
turn the thumbwheel until the oil tempera-
ture display appears.
The engine reaches its operating temperature
when in normal driving conditions, the oil
temperature is between 80°C (180°F) and
120°C (250°F) . If the engine is required to
work hard and the outside temperature is
high, the engine oil temperature can in-
crease. This does not present any problem as
long as the warning lamps
›››
page 47 table on page 47
or 
appear on the display.
42
Additional consumers
● Operation with the windscreen wiper lever*:
Press the rocker switch
main menu appears. Enter into the section
Driving data
move to the display Convenience con-
sumers
● Operation with the multi-function steering
wheel*: move with the buttons
to Driving data and enter with OK. Turn
the right thumbwheel until the Conven-
ience consumers
›››
Fig. 43 until
2
In addition, a scale will inform you of the cur-
rent sum of all the additional appliances.
move to the oil
2
Saving tips
Tips on how to save fuel will be displayed in
conditions that increase fuel consumption.
Follow them to reduce consumption. The indi-
cations appear automatically only with the ef-
ficiency programme. After a time, the tips will
disappear automatically.
If you wish to hide a saving tip immediately
after it appears, press any button on the
windscreen wiper lever*/multifunction steer-
ing wheel*.
›››
table on

do not
The essentials
›››
Fig. 43 until the
2
. With the rocker switch,
.
or
 
display appears.
Note
● If you hide a saving tip, it will reappear af-
ter you switch the ignition on again.
The saving tips do not appear in all situa-
●
tions, but rather with a large separation of
time.
Speed warning device
 
The speed warning device warns the driver
when they have exceeded the pre-set speed
limit by 3 km/h (2 mph). An audible warning
signal sounds, and the warning lamp  and
the driver message Speed limit excee-
will be displayed simultaneously on the
ded!
instrument panel. The warning lamp 
switches off when reducing speed below the
stored maximum limit.
Speed warning programming is recommen-
ded if you wish to be reminded of a maxi-
mum speed, such as when travelling in a
country with different speed limits or for a
maximum speed for winter tyres.
Setting speed limit warning
You can use the radio or the Easy Connect* to
set, alter or cancel the speed limit warning.
● Vehicles with radio: press the
> control button  Driver Assistant >
Speed warning .
button
SETUP