Seat Ateca Owner's Manual page 60

Engine oil specifications
Engine type
Petrol engines
Engines with particulate filter (DPF)
Diesel engines without particulate filter (DPF)
a) Use of engine oil compliant with the VW 504 00 specification instead of VW 508 00 may have a slight negative effect on the vehicle's exhaust gas values.
b) Only use recommended oils, otherwise you may damage the engine.
c) If the quality of the fuel available in the country does not fulfil the EN 228 (for petrol) and EN 590 (for diesel) standards.

›››
in Changing engine oil on page 302

›››
page 300
58
b)
Coolant
Engine compartment: coolant expan-
Fig. 63
sion tank cap.
The coolant tank is located in the engine
compartment
When the engine is cold, replace the coolant
when the level is below .
The essentials
Flexible service (LongLife)
VW 508 00
a)
VW 504 00
VW 507 00
–
›››

page 298.
Set Service (dependent on time/distance travel-
led)
VW 504 00
VW 507 00
VW 505 01 c)
VW 506 01 c)
Coolant specifications
The engine cooling system is supplied from
the factory with a specially treated mixture of
water and at least 40 % of the additive G13
(TL-VW 774 J), purple. This mixture gives the
necessary frost protection down to -25°C
(-13°F) and protects the light alloy parts of
the engine cooling system against corrosion.
It also prevents scaling and considerably rai-
ses the boiling point of the coolant.
To protect the cooling system, the percentage
of additive must always be at least 40 %,
even in warm climates where anti-freeze pro-
tection is not required.
If for weather reasons further protection is
necessary, the proportion of additive may be