Seat Ateca Owner's Manual page 159

Electric driver's seat adjustment*
Read the additional information carefully
›››

page 19
WARNING
If the electric front seats are used negli-
●
gently or without paying due attention, it can
cause serious injury.
● The front seats can also be electrically ad-
justed when the ignition is switched off. Nev-
er leave a child or any other person who may
need help in the vehicle.
● In the event of an emergency, electrical ad-
justment can be stopped by pressing any
control.
CAUTION
To avoid damaging the electrical components
of the front seats, please refrain from kneel-
ing on the seat or applying sharp pressure at
a single point to the seat cushion and back-
rest.
Note
● It may not be possible to electrically adjust
the seat if the vehicle battery is very low.
If the engine is started while the seats are
●
being electrically adjusted, the adjustment
will stop.
Seats and head restraints
Adjusting the front head restraints
Read the additional information carefully
›››

page 19
›››

Adjust the head restraint
that as far as possible the top of the head re-
straint is level with the top of your head.
When this is not possible, try to get as close
as possible to this position.
Adjustment of the rear head restraints
Rear centre head restraint: release
Fig. 150
point.
When transporting people in the back seat,
place the head restraints of the occupied
seats at a minimum of the next socket up
›››
.
Adjusting the head restraints
To set the head restraint higher, grasp the
–
sides with both hands and move it up-
wards, until you see it engage.
page 19 so
To set the head restraint lower down, press
–
›››
Fig. 150
the
1
downwards.
Removing the head restraint
To remove the head restraint, the correspond-
ing backrest must be partially folded forward.
Unlock the backrest
–
Move the head restraint upwards until it ar-
–
rives to the top.
Press button
–
neously pressing on the security hole
›››
Fig. 150 with a flat screwdriver a maxi-
mum of 5 mm wide, and remove the head
restraint.
Move the backrest until it engages properly
–
›››
.
Fitting the head restraint
To mount the external head restraints, the
corresponding backrest must be partially fol-
ded forward.
Unlock the backrest
–
Insert the head restraint bars into the
–
guides until they perceptibly engage. It
button and move it
›››
page 159.
›››
Fig. 150, while simulta-
1
2
›››
page 159.
»
157