Seat Ateca Owner's Manual page 181

The battery is located beneath a cover on the
back of the remote control.
● To open the cover, lift it slightly at the bot-
tom and slide it down.
● Remove the old battery.
Insert the new battery. When doing so, take
●
into account the polarity and use batteries of
›››
the same type .
● Replace the battery cover by inserting the
tabs at the top and pressing the bottom.
Range
The receiver is inside the vehicle. The remote
control, when fitted with new batteries, has a
range of several hundred metres. Obstacles
between the remote control and the vehicle,
bad weather conditions and discharged bat-
teries can considerably reduce the range of
the remote control.
CAUTION
● The radio frequency remote control con-
tains electronic components. Therefore, avoid
getting it wet and exposing it to knocks or di-
rect sunlight.
The use of inappropriate batteries may
●
damage the radio frequency remote control.
For this reason, always replace the used bat-
tery with another of the same voltage, size
and specifications.
Air conditioning
For the sake of the environment
● Please dispose of your used batteries cor-
rectly and with respect for the environment.
The remote control battery may contain
●
perchlorate. Observe the legal provisions re-
garding disposal.
Care should be taken so as not to operate
●
the remote control unintentionally so as to
prevent the auxiliary heater being switched
on accidentally.
Programming the auxiliary heater
Before programming it, check that the vehi-
cle's date and time are set correctly
The auxiliary heater is programmed in the
Auxiliary heater menu of the infotain-
ment system.
Open the Auxiliary heater menu.
● Press the button  in the Climatronic
control panel.
● Press the  function button.
Function button: function
: The auxiliary heater is immediately switched
Switch off
off.
Function button: function
, : Set to heat or ventilate the vehicle interi-
Heat Ventilate
or when the auxiliary heater is switched on. By pressing
the function button

mode.
: Opens the Auxiliary heater
Set
Departure time 1
Three different departure times (hh.mm) may be
programmed. If the auxiliary heater should only
be switched on a certain day of the week, this can
also be selected.
: The duration determines the operating
Duration
time of the auxiliary heater when switched on us-
ing the fast heating button  on the air condi-
tioning controls. The duration is also used to cal-
›››
.
culate the departure time for the manual air con-
ditioner. It can be set between 10 and 60 mi-
nutes at 10-minute intervals.

This returns to the main menu.
The programmed departure time determines
the approximate time it should take to reach
the temperature set in the vehicle. The start
of the heating operation is determined auto-
matically depending on the outside tempera-
ture.
Checking the programming
When a departure time is activated and the
ignition is switched off the control lamp of
the fast heating button  lights up for ap-
proximately 10 seconds.
, you can select the desired
menu.
, , :
Departure time 2 Departure time 3
»
179