Pid.gr Submenu – Configuring Groups Of Control Parameters - gefran 650 Installation And Instruction Manual

4. CONFIGURATION
4.14. PID.GR Submenu – Configuring groups of control parameters
Acronym Scrolling message
PID.GR PID GROUP
PARAMETERS CONFIG
92
Password
Level 1
Selecting the
parameter
PID.G.R
group to be
configured
Proportional
heating band
H.PB
or hysteresis in
ON-OFF control
Integral heating
time
H.IT
Derivative
heating time
H.DT
Maximum
limit of heating
H.P.HI
power
Minimum
limit of heating
H.P.LO
power
Proportional
cooling band
C.PB
or hysteresis in
ON-OFF control
Integral cooling
time
C.IT
Derivative
cooling time
C.DT
Lets you configure groups of control parameters. Groups of
control parameters must be enabled with the parameter PID.
GN = .1...4 on the MODE menu (the menu is not shown if
PID.GN = 0).
Groups are used to preconfigure sets of function parameters
that can be easily called when needed, without having to re-
configure the PID parameters every time. The number of pa-
rameters available in groups is less than the number on the
PID submenu. The number of parameters available in groups
is limited to those for PID heating and/or cooling control.
Parameter
page
Maximum
limit of cooling
93
C.P.HI
power
Minimum
limit of cooling
93
C.P.LO
power
Threshold PV for
the activation of
93
PV.THR
the group of PID
parameters
93
93
94
94
94
94
Description
Parameter
page
94
95
95
80208G_MHW_650-1250-1350_01-2017_ENG