Evnt.n - Setting The Event Number - gefran 650 Installation And Instruction Manual

4. CONFIGURATION

4.16.5. EVNT.N - Setting the event number

Acronym
EVNT.N EVENT NUMBER
The parameter shows and sets the event number.
The parameter appears if the parameter F.ou.x = EVENT.
Unit of measurement:
Options: 1...4
4.16.6. FB.OU.N - Setting the Function Block output number
Acronym
FB.OU.N FUNCTION BLOCK OUTPUT NUMBER
The parameter shows and sets the number of the Function Block assigned to the output.
The parameter appears if the parameter F.ou.x = FB.OUT.
Unit of measurement:
Options: 1...16
4.16.7. IN.DG.N - Setting the digital input number
Acronym
IN.DG.N DIGITAL INPUT NUMBER
The parameter shows and sets the number of the digital input assigned to the output.
The parameter appears if the parameter F.ou.x = IN.DIG.
Unit of measurement:
Options: 1...2
1...3
1...5
4.16.8. SWTCH - Setting the number of switchings for signal
Acronym
SWTCH NUMBER OF SWITCHING CYCLES
The parameter shows and sets the number of switchings (x1000) of the relay, exceeding which the signal is generated
OUTX.SWITCH ALARM where X is the number of output 1 or 2 or 3 or 4 if the output is relay, logic or triac.
The function is disabled if the parameter equals "0".
Unit of measurement:
Options: 0...9999
4.16.9. FAULT - State of output with broken input
Acronym
FAULT FAULT OUTPUT STATE
The parameter shows and sets the state (on, off) that the output assumes in case of broken input (Err, Sbr, ...), if the
output is direct or inverse.
Unit of measurement:
Options: OFF
On
102
Scrolling message
Number
Scrolling message
Number
Scrolling message
Number
Model 650 with option 2 digital inputs
Model 650 with option 3 digital inputs
Models 1250 and 1350 with option 5 digital inputs
Scrolling message
Number
Scrolling message
-
= Output is off
= Output is on
Submenu
OUTPU
Submenu
OUTPU
Submenu
OUTPU
Submenu
OUTPU
Submenu
OUTPU
80208G_MHW_650-1250-1350_01-2017_ENG
Attributes
R W
Attributes
R W
Attributes
R W
Attributes
R W
Attributes
R W