Configuring The Output - gefran 650 Installation And Instruction Manual

5. Examples and applicative notes

5.16.3.4. Configuring the output

Configure the output by selecting on the pull-down menu
one of the values listed in the Function Commands group
shown above in paragraph "5.16.2. Groups of variables."
This will be the output variable whose value will be changed
by the result of the logic operation processed with the input
variables data.
If the function given the output of the function
block is the same assigned to a digital input, the
state of this input has priority.
By clicking the output's icon you can reverse, from normally
open (NO) to normally closed (NC) and vice versa, the tran-
smitted state if the result of the logic operation is "true."
NO
End the configuration by giving a descriptive name to the
output so that it can be easily recognized for future use.
The name will be saved as part of the "configuration recipe"
only on the PC and will not be transferred to the controller.
Therefore, when the controllers are cloned, the controller to
which the configuration was copied will not contain this de-
scriptive name.
158
5.16.3.5. Configuring delays
You can insert a delay between the result of the logic opera-
tion and the change in value of the output variable.
These delays, which can differ from the "true" result and the
"false" result of the logic operation, are set on the DELAY
TIMER.
Delays can be counted in seconds or in minutes
Configure both delays:
•
•
When the time is set to 0 (zero), the change in value of the
output variable is instantaneous.
If both delays for ON and OFF equal 0, the DELAY TIMER is
ignored
NC
ON, which indicates how long after a "true" result of the
logic operation the value of the output variable is chan-
ged.
OFF, which indicates how long after a "false" result of
the logic operation the value of the output variable is
changed
80208G_MHW_650-1250-1350_01-2017_ENG