T.pro - Setting The Programmer Base Time - gefran 650 Installation And Instruction Manual

4. CONFIGURATION
The parameter shows and sets enabling of the setpoint programmer for P or PV models.
Unit of measurement:
Options: OFF
On

4.19.15. t.Pro - Setting the programmer base time

Acronym
t.Pro PROGRAMMER BASE TIME DEFINITION
The parameter shows and sets the base time used by the programmer.
The parameter appears if the parameter PROGR = On.
Unit of measurement:
Options: HH.MM = Base time calculated in hours:minutes
MM.SS = Base time calculated in minutes:seconds
4.19.16. ENERG - Enabling the energy counter function
Acronym
ENERG ENERGY COUNTER ENABLE
The parameter shows and sets enabling of the energy counter function.
The Energy Counter function is explained in detail in paragraph "5.15. Energy Counter" on page 154.
Unit of measurement:
Options: OFF
On
4.19.17. T.SAMP - Main input sample time
Acronym
T.SAMP MAIN INPUT SAMPLE TIME
The parameter shows and sets the main input sample time.
Unit of measurement:
Options: 60
120
4.19.18. FREQZ - Defining power line frequency
Acronym
FREQZ LINE FREQUENCY
The parameter shows and sets the power line frequency
Unit of measurement:
Options: 50
60
114
-
= Setpoint programmer disabled
= Setpoint programmer enabled
Scrolling message
-
Scrolling message
-
= Energy counter disabled
= Energy counter enabled
Scrolling message
Milliseconds
Scrolling message
Hz
Submenu
MODE
Submenu
MODE
Submenu
MODE
Submenu
MODE
80208G_MHW_650-1250-1350_01-2017_ENG
Attributes
R W
Attributes
R W
Attributes
R W
Attributes
R W