Dell iDRAC6 User Manual page 93

The Network Security screen appears.
4 Configure IP filtering and blocking settings as needed. See Table 5-6 for
descriptions of the IP filtering and blocking settings.
5 Click Apply.
6 Click the appropriate button to continue. See Table 5-7.
Table 5-6. IP Filtering and Blocking Settings
Settings
IP Range Enabled
IP Range Address
IP Range Subnet
Mask
IP Blocking
Enabled
IP Blocking Fail
Count
IP Blocking Fail
Window
IP Blocking Penalty
Time
Table 5-7. Network Security Buttons
Button
Print
Refresh
Description
Enables the IP Range checking feature, which defines a range of
IP addresses that can access iDRAC6. The default is Disabled.
Determines the acceptable IP subnet address. The default is
192.168.1.0.
Defines the significant bit positions in the IP address.
The subnet mask should be in the form of a netmask, where the
more significant bits are all 1's with a single transition to all
zeros in the lower-order bits. The default is 255.255.255.0.
Enables the IP address blocking feature, which limits the
number of failed login attempts from a specific IP address for a
preselected time span. The default is Disabled.
Sets the number of login failures attempted from an IP address
before the login attempts are rejected from that address.
The default is 10.
Determines the time span in seconds within which IP Block
Fail Count failures must occur to trigger the IP Block Penalty
Time. The default is 3600.
The time span in seconds that login attempts from an
IP address with excessive failures are rejected. The default
is 3600.
Description
Prints the Network Security values that appear on the screen.
Reloads the Network Security screen.
Configuring iDRAC6 Enterprise Using the Web Interface
93