Dell iDRAC6 User Manual page 197

3 Locate DSM_BMU_SOLProxy in the list of services and right-click to
start the service.
Depending on the console you use, there are different steps for accessing SOL
Proxy. Throughout this section, the management station where the SOL
Proxy is running is referred as the SOL Proxy Server.
For Linux
The SOL Proxy will start automatically during system startup. Alternatively,
you can go to directory /etc/init.d and use the following commands to
manage the SOL Proxy service:
solproxy status
dsm_bmu_solproxy32d start
dsm_bmu_solproxy32d stop
solproxy restart
Using Telnet with SOL Proxy
This assumes that the SOL Proxy service is already up and running on the
management station.
For Windows 2003:
1 Open a command prompt window on your management station.
2 Enter the telnet command in the command-line and provide
localhost as the IP address if the SOL Proxy server is running in the
same machine and the port number that you specified in the SOL Proxy
installation (the default value is 623). For example:
telnet localhost 623
For Linux:
1 Open a Linux shell on your management station.
2 Enter the telnet command and provide localhost as the IP address
of the SOL Proxy server and the port number that you specified in the
SOL Proxy installation (the default value is 623). For example:
telnet localhost 623
Configuring and Using Serial Over LAN
197