Dell iDRAC6 User Manual page 253

where <level> is one of the following:
• 2 (User)
• 3 (Operator)
• 4 (Administrator)
For example, to set the IPMI LAN channel privilege to 2 (User), enter
the following command:
racadm config -g cfgIpmiLan -o
cfgIpmiLanPrivilegeLimit 2
Set the IPMI LAN channel encryption key, if required, using a
b
command such as the following:
NOTE:
iDRAC6 IPMI supports the RMCP+ protocol. See the IPMI 2.0
specifications for more information.
racadm config -g cfgIpmiLan -o
cfgIpmiEncryptionKey <key>
where <key> is a 20-character encryption key in a valid
hexadecimal format.
2 Configure IPMI Serial over LAN (SOL) using the following command:
racadm config -g cfgIpmiSol -o cfgIpmiSolEnable 1
NOTE:
The IPMI SOL minimum privilege level determines the minimum
privilege required to activate IPMI SOL. For more information, see the IPMI 2.0
specification.
Update the IPMI SOL minimum privilege level using the following
a
command:
racadm config -g cfgIpmiSol -o
cfgIpmiSolMinPrivilege <level>
where <level> is one of the following:
• 2 (User)
• 3 (Operator)
• 4 (Administrator)
Using the RACADM Command Line Interface
253