Configuring Ipmi Over Lan - Dell iDRAC6 User Manual

racadm config -g cfgLanNetworking -o cfgNicNetmask
255.255.255.0
racadm config -g cfgLanNetworking -o cfgNicGateway
192.168.0.120
racadm config -g cfgLanNetworking -o cfgNicUseDHCP 0
racadm config -g cfgLanNetworking -o
cfgDNSServersFromDHCP 0
racadm config -g cfgLanNetworking -o cfgDNSServer1
192.168.0.5
racadm config -g cfgLanNetworking -o cfgDNSServer2
192.168.0.6
racadm config -g cfgLanNetworking -o
cfgDNSRegisterRac 1
racadm config -g cfgLanNetworking -o cfgDNSRacName
RAC-EK00002
racadm config -g cfgLanNetworking -o
cfgDNSDomainNameFromDHCP 0
racadm config -g cfgLanNetworking -o cfgDNSDomainName
MYDOMAIN
NOTE:
If cfgNicEnable is set to 0, iDRAC6 LAN is disabled even if DHCP is enabled.

Configuring IPMI Over LAN

1 Configure IPMI over LAN by entering the following command:
racadm config -g cfgIpmiLan -o cfgIpmiLanEnable 1
NOTE:
This setting determines the IPMI commands that can be executed from the
IPMI over LAN interface. For more information, see the IPMI 2.0 specifications.
Update the IPMI channel privileges by entering the following
a
command:
racadm config -g cfgIpmiLan -o
cfgIpmiLanPrivilegeLimit <level>
252
Using the RACADM Command Line Interface