Configuring Ip Filtering And Ip Blocking - Dell iDRAC6 User Manual

Table 5-4. VLAN Settings
Button
Enable VLAN ID
VLAN ID
Priority
Table 5-5. Network Configuration Buttons
Button
Advanced Settings
Print
Refresh
Apply

Configuring IP Filtering and IP Blocking

NOTE:
You must have Configure iDRAC6 privilege to perform the following steps.
1 Click System→ Remote Access→ iDRAC6.
2 Click the Network/Security tab.
The Network screen appears.
3 Click Advanced Settings.
92
Configuring iDRAC6 Enterprise Using the Web Interface
Description
Yes—Enabled. No—Disabled. If enabled, only matched Virtual
LAN (VLAN) ID traffic is accepted.
NOTE:
The VLAN settings can only be configured through the
CMC Web Interface. iDRAC6 only displays the current enablement
status; you can not modify the settings on this screen.
VLAN ID field of 802.1g fields. Displays a value from 1 to 4094
except 4001 to 4020.
Priority field of 802.1g fields. This is used to identify the
priority of the VLAN ID and displays a value from 0 to 7 for the
VLAN Priority.
Description
Displays the Network Security screen, allowing you to enter the
IP Range and IP Blocking attributes.
Prints the Network configuration values that appear on the
screen.
Reloads the Network screen.
Saves any new settings made to the network configuration
screen.
NOTE:
Changes to the NIC IP address settings will close all user
sessions and require users to reconnect to iDRAC6 Web interface
using the updated IP address settings. All other changes will
require the NIC to be reset, which may cause a brief loss in
connectivity.