Dell iDRAC6 User Manual page 301

Table 19-1. LAN Parameters (continued)
Item
Alert Destination 1
IPv4 Settings
IPv4
RMCP+ Encryption
Key
IP Address Source
Ethernet IP Address If the IP Address Source is set to DHCP , this field displays the
Subnet Mask
Default Gateway
DNS Servers from
DHCP
Description
if LAN Alert Enabled is set to On, enter the IP address where
PET LAN alerts will be forwarded.
Enable or disable support for the IPv4 connection.
Select Enabled or Disabled IPv4 protocol support.
The default is enabled.
Press <Enter> to edit the value and <Esc> when finished.
The RMCP+ Encryption key is a 40-character hexadecimal
string (characters 0-9, a-f, and A-F). RMCP+ is an IPMI
extension that adds authentication and encryption to IPMI.
The default value is a string of 40 0s (zeros).
Select between DHCP and Static. When DHCP is selected,
the Ethernet IP Address, Subnet Mask, and Default Gateway
fields are obtained from a DHCP server. If no DHCP server is
found on the network, the fields are set to zeros.
When Static is selected, the Ethernet IP Address, Subnet
Mask, and Default Gateway items become editable.
IP address obtained from DHCP .
If the IP Address Source is set to Static, enter the IP address
you want to assign to iDRAC6.
The default is 192.168.0.120.
If the IP Address Source is set to DHCP , this field displays the
subnet mask address obtained from DHCP .
If the IP Address Source is set to Static, enter the subnet mask
for iDRAC6. The default is 255.255.255.0.
If the IP Address Source is set to DHCP , this field displays the
IP address of the default gateway obtained from DHCP .
If the IP Address Source is set to Static, enter the IP address of
the default gateway. The default is 192.168.0.1.
Select On to retrieve DNS server addresses from a DHCP
service on the network. Select Off to specify the DNS server
addresses below.
Using iDRAC6 Configuration Utility
301