Axia Fusion Installation And User Manual page 26

6. Rotate the Options encoder to highlight the Current Source window. (Highlighted options are bordered
in yellow), and then press the Encoder.
7. You'll now see a list of your available Sources (in this case, just one: the one we just configured. If you
already have an Axia network deployed, you may see a larger list.)
8. Rotate the Options encoder to highlight the source you just created. Press the encoder to select the high-
lighted source.
9. Press the Program 1 key on the fader strip; it will illuminate to show you've assigned that fader to PGM-1.
Press the ON key at the bottom of the fader strip and move the fader up. Congratulations: you've got audio!
The meters on your display should be active, as shown below.
To hear the audio, make sure you have selected Program 1 as your CR Monitor source, using the controls on
your Monitor module, and that the volume is at an appropriate level (the level meters onscreen will show the relative
volume you've set).
Now, sit back and enjoy some music as you read the remainder of this manual, or continue to explore the
Configuration pages of your PowerStation; the details of these options can be found in the Configuration section of
this manual.
© 2017 Axia Audio - Rev 3.2