Commissioning; General Requirements; Warnings; Operating Via Simatic Pdm - Siemens SITRANS FC410 Operating Instructions Manual

Commissioning

6.1

General requirements

Before commissioning it must be checked that:
● The device has been installed and connected in accordance with the guidelines provided
in Installing/Mounting (Page 27) and Connecting (Page 37).
● Device installed in hazardous area meets the requirements described in Installation in
hazardous locations (Page 16).
6.2

Warnings

Improper handling
The sensor connected to this device can be operated with high pressure and corrosive
media. Therefore improper handling of the device can lead to serious injuries and/or
considerable material damage.
Commissioning and operation with pending error
If an error message appears, correct operation in the process is no longer guaranteed.
• Check the gravity of the error.
• Correct the error.
• If the error still exists:
6.3

Operating via SIMATIC PDM

SIMATIC PDM is a software package used to commission and maintain process devices.
Further information can be found at: www.siemens.com/simatic-pdm
(www.siemens.com/simatic-pdm).
FC410 with Modbus
Operating Instructions, 02/2016, A5E33120874-AC
WARNING
WARNING
– Take the device out of operation.
– Prevent renewed commissioning.
6
51