Determining A Location - Siemens SITRANS FC410 Operating Instructions Manual

Installing/Mounting
4.1 Flowmeter installation
Hot surfaces resulting from hot process media
Danger of burns resulting from surface temperatures above 70 °C (155 °F).
• Take appropriate protective measures, for example contact protection.
• Make sure that protective measures do not cause the maximum permissible ambient
External stresses and loads
Damage to device by severe external stresses and loads (e.g. thermal expansion or pipe
tension). Process media can be released.
• Prevent severe external stresses and loads from acting on the device.
Wetted parts unsuitable for the process media
Danger of injury or damage to device.
Hot, toxic and corrosive media could be released if the process medium is unsuitable for
the wetted parts.
• Ensure that the material of the device parts wetted by the process medium is suitable for
Note
Material compatibility
Siemens can provide you with support concerning selection of sensor components wetted by
process media. However, you are responsible for the selection of components. Siemens
accepts no liability for faults or failures resulting from incompatible materials.
4.1.2

Determining a location

Electromagnetic fields
Do not install the flowmeter in the vicinity of strong electromagnetic fields, for example near
motors, variable frequency drives, transformers etc.
28
CAUTION
temperature to be exceeded. Refer to the information in Chapter "Rated operating
conditions (Page 94)".
CAUTION
WARNING
the medium. Refer to the information in "Technical data" (Page 99).
CAUTION
Operating Instructions, 02/2016, A5E33120874-AC
FC410 with Modbus