2.4.2
Inputting Reset Signals to the Debugging MCU Board
When reset signals must be input, such as the case when activating the High-performance
Embedded Workshop or debugging, they can be manually input from the reset switch on the
debugging MCU board. For details on inputting reset signals, see table 2.5.
Table 2.5 Correspondence of Reset Switch Settings
Setting of SW4
Turned to '3' of silk-
screened label
Turned to '1' of silk-
screened label
Note: This reset switch is used to manually input reset signals to the debugging MCU board.
When the user system is connected, this reset switch is also available for inputting reset
signals to the debugging MCU board, however, note that no reset signal is output to the
user system.
Figure 2.14 Reset Switch
Reset Signal Input to the Debugging MCU Board
Reset signal input from the reset switch is canceled. (factory setting)
Reset signal is input from the reset switch.
35