Table of Contents
Advertisement
Item
4. Settings when the malfunction
occurred
5. Failure phenomenon
6. Error in debugging
7. The High-performance Embedded
Workshop does not link-up with the
debugging MCU board.
For errors other than the above, fill in the box below.
Symptom
Enter the operational settings of the debugging MCU board.
(1) Power-selection switch:
EXTERNAL or USER SYSTEM (circle either item).
(2) Clock-selection jumper:
XTAL or USER CLK (circle either item).
Input clock:
MHz
(3) User-system input signal enabling/disabling switches:
UNMI: ENABLE or DISABLE (circle either item).
URES: ENABLE or DISABLE (circle either item).
UCON: ENABLE or DISABLE (circle either item).
(4) Operating frequency:
Content of the error message
MHz
57
Advertisement
Table of Contents
