Table of Contents
Advertisement
1.4
Hardware Configuration
As shown in figure 1.2, the usable configuration of the debugging MCU board consists of the
main unit, FFC cable, user system interface board, and power cable. The debugging MCU board is
connected, via the E10A-USB emulator, to the host computer over a USB 1.1/2.0 (Full-Speed)
link.
The host computer, E10A-USB emulator, and external power supply must be separately obtained
by the user.
Figure 1.2 Hardware Configuration of the Debugging MCU Board
8
Host computer
External
power supply
(5-V DC)
User system
interface board
User system
(IC-socket interface)
E10A-USB emulator
(separately available)
USB1.1/USB2.0
(Full-Speed)
Power cable
FFC cable
Main unit of
the debugging
MCU board
Advertisement
Table of Contents
