Renesas HS7125EDB01H User Manual page 37

3. Fasten the user system interface board to the IC socket on the user system with the four screws
(M2.0 10 mm) provided. Tighten each of the screws a little at a time, alternating between
x
those on opposing corners. Do not concentrate on fully tightening one screw at a time. Take
special care, such as manually securing the IC-socket soldered area, to prevent damage to the
soldered IC socket due to excessive tightening of the screws or twisting of components.
Screws (M2.0 x 10 mm)
User system interface board
Pin 1
IC socket
User system
Figure 2.5 Connecting the User System Interface Board to the User System
23