Table of Contents
Advertisement
Section 1 Product Overview ..............................................................................1
1.1
Introduction....................................................................................................................... 1
1.2
Components ...................................................................................................................... 4
1.3
Components in the Package for the Debugging MCU Board ........................................... 5
1.4
Hardware Configuration ................................................................................................... 8
1.5
Environmental Conditions ................................................................................................ 15
Section 2 Setting Up the Debugging MCU Board.............................................17
2.1
Flow Chart before Using the Debugging MCU Board...................................................... 17
2.2
Setting Up the Debugging MCU Board ............................................................................ 18
2.2.1
Connecting the Debugging MCU Board to the E10A-USB Emulator................. 18
2.2.2
Connecting the Debugging MCU Board to the User System............................... 21
2.2.3
Setting the Power-Selection Switch ..................................................................... 24
2.2.4
Connecting the Power Cable................................................................................ 25
2.2.5
Setting the Clock-Selection Jumper..................................................................... 26
2.2.6
Installing a Crystal Resonator .............................................................................. 27
2.2.7
Setting the User-System Input Signal Enabling/Disabling Switches ................... 28
2.2.8
Connecting the System Ground ........................................................................... 29
2.3
Setting the E10A-USB Emulator ...................................................................................... 30
2.3.1
Setting the DIP Switches of the E10A-USB Emulator ........................................ 30
2.3.2
CD-R.................................................................................................................... 31
2.3.3
Connecting the E10A-USB Emulator to the Host Computer............................... 32
2.3.4
Setting Up the E10A-USB Emulator ................................................................... 33
2.3.5
Activating the High-performance Embedded Workshop..................................... 33
2.4
Setting Up the Debugging MCU Board for Single Operation .......................................... 34
2.4.1
Setting Switches on the Debugging MCU Board................................................. 34
2.4.2
Inputting Reset Signals to the Debugging MCU Board ....................................... 35
Section 3 Hardware Specifications ....................................................................37
3.1
External Dimensions of the Debugging MCU Board ....................................................... 37
3.2
Resulting Dimensions after Connecting User System Interface Board............................. 39
3.3
Recommended Dimensions for User System Mount Pad (Footprint)............................... 39
3.3.1
Using the PLQP0064KB-A (FP-64K) Package ................................................... 40
3.3.2
Using the PRQP0064GB-A (FP-64A) Package................................................... 41
3.3.3
Using the PLQP0048JA-A (FP-48F) Package..................................................... 42
3.4
Installing the MCU to the User System ............................................................................ 43
Contents
iii
Advertisement
Table of Contents
