The E10A-USB emulator is connected to the host computer via the USB 1.1, and also to the USB
port conforming to USB 2.0. Figure 2.13 shows the system configuration.
Figure 2.13 System Configuration when Connecting the E10A-USB Emulator to the Host
2.3.4
Setting Up the E10A-USB Emulator
Set up the E10A-USB emulator's firmware referring to section 3.10, Setting Up the Emulator, and
section 3.11, System Check, in the SuperH™ Family E10A-USB Emulator User's Manual.
2.3.5
Activating the High-performance Embedded Workshop
Activate the High-performance Embedded Workshop referring to section 4, Preparations for
Debugging, in the SuperH™ Family E10A-USB Emulator User's Manual, which describes the
activation procedure.
Computer
33