Section 2 Setting Up The Debugging Mcu Board; Flow Chart Before Using The Debugging Mcu Board - Renesas HS7125EDB01H User Manual

Section 2 Setting Up the Debugging MCU Board

2.1

Flow Chart before Using the Debugging MCU Board

Unpack the debugging MCU board and prepare it for use as follows:
READ the reference sections shaded in figure 2.1 before
using the debugging MCU board. Incorrect operation will
damage the user system and the debugging MCU board uct.
The USER PROGRAM will be LOST.
Unpack the debugging MCU board
Check the components against the component list
Set up the debugging MCU board
- Connect the E10A-USB emulator
- Connect the user system
- Set the switches of the debugging MCU board
Set up the E10A-USB emulator
- Install the emulator's software
(Check the components and register the user information.)
- Insert the emulator
- Set up the main unit of the emulator
Start the High-performance Embedded Workshop
Turn on the user system
Input the user system reset signal
Figure 2.1 Preparation Flow Chart for the Debugging MCU Board
WARNING
Reference
Component list
Section 2 in the
Debugging MCU
Board User's
Manual (this
manual)
Section 3 in the
E10A-USB
Emulator User's
Manual
Section 4 in the
E10A-USB
Emulator User's
Manual
When the debugging MCU
board is used first.
When the debugging MCU
board is used for second
time or later.
17