Initial Setting Of The Emulator Debugger - Renesas R0E00030AKCT00 User Manual

E30A Emulator User's Manual

3.2 Initial Setting of the Emulator Debugger

R32C/100 E30A emulator debugger starts up and the Init dialog box appears. When you finished setting of each tab, click
"OK".
3.2.1 MCU Tab
This tab permits you to select an MCU file and the connected emulator, and specify whether to debug a program in CPU
rewrite mode, whether to use ECC for E2 data flash and a work area for the debug monitor program.
(1) MCU
An MCU file (MCU type name_E30A.mcu) contains the information specific to the target MCU. Select the MCU file
applicable to the target MCU.
- Click the "Refer..." button to open the Select MCU File dialog box.
- Select the desired MCU file.
Note on MCU file:
When you cannot select the MCU to be used, add the MCU file to the folder below. For details on
getting the MCU file, contact your local distributor.
Install folder of the High-performance Embedded Workshop\Tools\Renesas\DebugComp\Platform
\PDTarget\PD100E30A\McuFiles
(2) Serial No.
Select the serial number of the emulator to be used from the connected emulator list.
R20UT0422EJ0501 Rev.5.01
Mar 15, 2016
3. Starting Up the Emulator Debugger
Page 32 of 65