Direct Operation; Switchover Between Automatic And Direct Operation - ABB i-bus KNX FCL/S 1.6.1.1 Product Manual

®
ABB i-bus KNX
Planning and application
4.1.3

Direct operation

With direct fan control via the ABB i-bus
three floating contacts. A single-speed, two-speed or three-speed fan can be connected.
The device sets the fan speed in accordance with a value received via the ABB i-bus
ceived as a 1 byte value.
1 byte value
4.1.4

Switchover between automatic and direct operation

The device can switch between automatic operation and direct operation. The changeover to manual fan
control is implemented via a 1 bit value. The fan speed is switched in accordance with the 1 byte value re-
ceived.
Fan control is changed back to automatic operation if a 1 is received on the respective communication ob-
ject.
The current status of automatic operation is fed-back via a 1 bit value.
86 2CDC508116D0203 | FCL/S x.6.1.1
Hexadecimal
0 00
1 01
2 02
3 03
>3 >03
®
, a fan drive is connected directly to the device and switched via
Binary value bit
76543210
00000000 0 (OFF)
00000001 Fan speed 1
00000010 Fan speed 2
00000011 Fan speed 3
>00000011 Values greater than 3 are ignored
®
. The value is re-
Fan speed