Installation; Mounting Into Ops Display - DFI OPS150-CS User Manual

X Installation

Mounting into OPS Display

Please follow the steps and attend to the safety cautions while
mounting the OPS module into the OPS display.
1. Power off the OPS display and unplug its power cord to
eliminate any chance of electric shock.
2. Insert the OPS module into the OPS slot on the OPS dis-
play while making sure the ventilation holes face the ex-
terior of the slot and align with those on the OPS display.
3. Push the module all the way into the slot. The gap between
the module panel and the slot shall close up.
4. Insert the mount screws into the mounting screw holes, and fasten them tight.
Note:
Two additional spring screws are attached to the front panel and can be used for
mounting if the OPS display has tapped screw holes for them.
User's Manual | OPS150-CS
Mounting
Screw Hole
Mounting
Screw Hole
Important:
When removing the OPS module, completely cut off the power of both the OPS
module and the OPS display, and remove the power cable to rule out any chances
of ESD/EOS damage to the system.
Chapter 2
HARDWARE INSTALLATION
9