Table of Contents
Advertisement
Chapter 5 - Ports and Connectors
Display Interfaces
The display ports consist of the following:
•
1 HDMI or DP++ (optional)
•
1 VGA or DP++ (optional)
COM 3
HDMI
SATA 2 SATA Power
1
1
LINE-out
Realtek ALC888
SATA 3.0
80
EIO
2
1
1
JP1
12
1
1
JP2
12
1
Battery
JP3
1
SPI Flash
JP4
1
BIOS
VGA
COM 4
VGA Port
The VGA port is used for connecting a VGA monitor. Connect the monitor's 15-pin D-shell cable
connector to the VGA port. After you plug the monitor's cable connector into the VGA port,
gently tighten the cable screws to hold the connector in place. Note that if you choose to wire
a DP port on the expansion board (BOM option), this VGA port will not be available. Please
refer to "Display Interfaces (expansion board)" below.
HDMI Port
The HDMI port, which carries both digital audio and video signals, is used to connect the
HDMI port of an LCD monitor or a digital TV. Note that you can choose to wire this port as a
DP port (BOM option).
DP Port (optional)
The DP port is a digital display interface used to connect a display device such as a computer
monitor. It is used to transmit audio and video simultaneously. The interface, which is devel-
oped by VESA, delivers higher performance than any other digital interfaces.
Chapter 2 Hardware Installation
Chapter 5 Ports and Connectors
LAN 2
LAN 1
USB 2
HDMI
USB 4
USB 3
USB 1
DC-in
MIC-in
USB 3.0
USB 3.0
Intel
WGI210IT
DDR4
DDR4
DDR4
DDR4
Auto PWR ON (JP7)
1
JP7
Front
Power
Panel
(JP11)
Button
6
3
VGA
COM 2
COM 1
Chapter 5
BIOS Setting
Configure the display devices in the Advanced menu ("Video Configuration" submenu) of the
BIOS. Refer to Chapter 7 for more information.
Driver Installation
Install the graphics driver. Refer to Chapter 8 for more information.
15
www.dfi.com
Advertisement
Table of Contents
