Table of Contents
Advertisement
Chapter 3 - Installing Devices
Connecting the I/O Board
The system supports 32 digital inputs and outputs. The I/O board that came with the package
can be connected to the system to test the digital input and output function. Please observe the
following guidelines and follow the procedure to connect the I/O board.
1.
Make sure the system and all other peripheral devices connected to it have been powered
off.
2.
Disconnect all power cords and cables.
3.
Connect one end of the USB cable (type-A connector) to the system and the other end of
the USB cable (type-B connector) to the I/O board.
4.
Connect the I/O board to the system's intrusion detection connector (labeled door 1~6) us-
ing the red cable.
5.
Connect the I/O board to the system's DIO port (labeled DO: 17~32) using the blue cable.
6.
Connect the I/O board to the system's DIO port (labeled DO: 1~16) using the green cable.
7.
Connect the I/O board to the system's DIO port (labeled DI: 17~32) using the yellow cable.
8.
Connect the I/O board to the system's DIO port (labeled DI: 1~16) using the orange cable.
Note:
The tact buttons on the I/O board can be used to invoke a door intrusion event or set
the high/low level of a digital I/O port. You can also use the demonstration application
to alter a digital I/O port's level. For more information, please refer to the software ap-
plication guide.
Chapter 3 Installing Devices
Chapter 3
Powering on the System and Connecting the Display
To power on the system, simply connect the 4-pin power cable to the system and the system will
be automatically powered on. If you want to use a power or a reset switch (tact button), they are
located on the system board as shown in the following picture.
To connect the display, use a DisplayPort cable to connect one of the DP ports to a display device.
Power LED
HDD LED
Power Button
Reset Button
Orange DI: 1~16
Yellow DI: 17~32
Green DO: 1~16
Blue DO: 17~32
Red: Door 1~6
11
4-pin DC-in
DP 0
DP 1
DP 2
Advertisement
Table of Contents
