ABB REG670 Commissioning Manual page 9

Generator protection REG670 2.2 IEC and Injection equipment REX060, REX061, REX062
Commissioning manual
Section 9 Establishing connection and verifying the LON
communication............................................................... 95
Communication via the rear ports ....................................................95
LON communication.................................................................... 95
The LON Protocol........................................................................96
Hardware and software modules.................................................96
Optical budget calculation for serial communication with LON ........98
Section 10 Establishing connection and verifying the IEC 61850
communication............................................................... 99
Overview...........................................................................................99
Setting the station communication....................................................99
Verifying the communication.......................................................... 100
Section 11 Establishing connection and verifying the IEEE
C37.118/1344 communication..................................... 101
Overview.........................................................................................101
Setting the PMU station communication (PMU Report)................. 101
Setting the PMU station communication (PMU configuration)........102
Setting the TCP/UDP client communication................................... 103
Verifying the communication.......................................................... 106
Verifying the IEEE C37.118/1344 TCP communication............ 107
Verifying the IEEE C37.118/1344 UDP communication............ 113
Optical budget calculation for PMU - PDC communication............ 114
Section 12 Testing IED operation...................................................115
Preparing for test............................................................................ 115
Requirements............................................................................ 115
Preparing the IED to verify settings........................................... 117
Activating the test mode................................................................. 118
Preparing the connection to the test equipment............................. 118
Connecting the test equipment to the IED......................................119
Releasing the function to be tested................................................ 120
Verifying analog primary and secondary measurement................. 121
Testing the protection functionality................................................. 122
Forcing of binary input/output signals for testing............................ 122
Forcing concept......................................................................... 122
How to enable forcing................................................................122
Enable forcing by using LHMI.............................................. 122
Enable forcing using TESTMODE function block.................123
How to change binary input/output signals using forcing.......... 123
Forcing by using LHMI......................................................... 123
Forcing by using PCM600.................................................... 125
Table of contents
3