Ds-Mode - Avaya X330WAN User Manual

Note: If
N/A
not loaded correctly. Download the Device Manager software again.

ds-mode

Use the
ds-mode
Note: After setting the controller's mode, this command:
1. Erases startup-config.
2. Resets the device.
Syntax
ds-mode [e1
Parameters
e1
t1
Example
X330WAN-2DS1-1(configure)# ds-mode e1
Your startup-config file will be erased!
Your telnet session will be disconnected.
This operation may take a few minutes
The WAN module will reset, in order to make the required change.
Do you want to continue (Y/N)?
Note: If this command is entered when the correct mode is selected (for example,
entering
generated.
Caution: This action takes approximately 20 seconds. Do not enter any commands
after confirming restart until after the restart process is complete.
Avaya X330WAN User's Guide
is displayed for the EW_Archive file, the Device Manager software is
command to set the controller's mode.
|
t1]
Sets the device to E1 mode. All controllers are set to operate as E1.
Sets the device to T1 mode. All controllers are set to operate as T1. This is
the default.
when the device is already in E1 mode), no errors are
ds1-mode e1
General: Device Commands
95