Configuring Loopback Interfaces; Configuring Fast Ethernet Interfaces - Avaya X330WAN User Manual

Chapter 3 Initial Configuration

Configuring Loopback Interfaces

All CLI commands mentioned in this section are described in Chapter 6: X330WAN
CLI Commands.
To configure Loopback interfaces:
1 Enter the Interface Loopback mode using the
interface Loopback [<interface number>[.ip-interface]]
For example: typing
the Loopback1 interface parameters.
The prompt changes to
where
2 Use the
and subnet mask to the interface.
3 Type
The prompt returns to
Note: The first IP interface created in the X330WAN automatically becomes the PMI
(Primary Management Interface), described in detail on page 34. It is recommended
to configure the Loopback interface as the first Layer 2 interface and to configure an
IP interface on it. After the PMI is configured, the following message appears:
The primary management interface has changed.
For this change to take effect, you need to copy running-config
startup-config and then reset the device.
Enter the
stage.

Configuring Fast Ethernet Interfaces

All CLI commands mentioned in this section are described in Chapter 6: X330WAN
CLI Commands.
To configure Fast Ethernet interfaces:
1 Type
The prompt changes to
2 Use the
and subnet mask to the interface.
3 Type
The prompt returns to
Note: The first IP interface created in the X330WAN automatically becomes the
PMI, described in detail on page 34. It is recommended to configure the Loopback
interface as the first Layer 2 interface and to configure an IP interface on it. After the
20
interface loopback 1
X330WAN-2DS1-N(super-if:Loopbackn)#
is the switch number and
N
ip address <ip address> <mask>
to return to Supervisor mode.
exit
X330WAN-2DS1-N(super)#
copy running-config startup-config
interface FastEthernet 1
X330WAN-2DS1-N(super-if:FastEthernet1)#
ip address <ip address> <mask>
to return to Supervisor mode.
exit
X330WAN-2DS1-N(super)#
enters a context for configuring
is the Loopback interface number.
n
command to assign an IP address
and
reset
to enter the Interface Configuration mode.
command to assign an IP address
Avaya X330WAN User's Guide
command.
commands at this