Interface Console; Ppp Authentication (Console Interface Context); Speed (Console Context) - Avaya X330WAN User Manual

interface Console

Use the
interface Console
console
create the interface. The
parameters.
Syntax
[no] interface Console
Example
X330WAN-2DS1-1(configure)# interface Console

ppp authentication (Console interface context)

Use the
ppp authentication
sent for authentication, if necessary.
Syntax
ppp authentication {pap|chap|none}
Parameters
Password Authentic Protocol. Unencrypted password sent for authentication.
pap
Challenge Handshake Authentication Protocol. Encrypted password sent for
chap
authentication.
No password sent.
none
Example
To select the CHAP authentication protocol:
X330WAN-2DS1-1(config-if:CON)# ppp authentication chap

speed (Console context)

Use the
speed
ports.
Note:
1. This command is executed from the Console interface.
2. The peer baud-rate must be set to the same value.
Syntax
speed {9600|19200|38400}
Avaya X330WAN User's Guide
command to enter the Console interface (
context) to PPP configure mode. For LAN interfaces, use this command to
form of this command sets the default Console
no
command to set the type of password that should be
command to set the PPP baud rate to be used by asynchronous PPP
Console (RS232) Interface CLI Commands
interface
111