Controller Cli Commands (X330Wan-2Ds1 Only); Cablelength Long (Controller Context) - Avaya X330WAN User Manual

ip-interface
Example
X330WAN-2DS1-1(configure)# interface FabricFastEthernet 1
X330WAN-2DS1-1(configure)# interface FabricFastEthernet 1:1
X330WAN-2DS1-1(configure)# no interface FabricFastEthernet 1.1
To enter
IP-interface of 1:
X330WAN-2DS1-1(configure)# interface FabricFastEthernet 1:1.1

Controller CLI Commands (X330WAN-2DS1 Only)

This section contains a list of all Controller related CLI commands.

cablelength long (Controller context)

Use the
a cable length (line build-out) longer than 655 feet for a T1 trunk with a CSU
interface. This command configures the levels using gain/attenuation. The
of this command restores the cablelength long parameters to their default values
(Tx=0db level, Rx=gain26).
Note: This command can only be performed if the controller is set to T1.
Syntax
[no] cablelength long {gain26|gain36} {-15db|-22.5db|-7.5db| 0db}
Parameters
gain26
gain36
-15db
-22.5db
Avaya X330WAN User's Guide
The IP interface number within this interface (as a number of IP
interfaces might be bound to an Layer 3 interface). An integer
from 0 to 1024.
interface FabricFastEthernet
command to configure transmit and receive levels for
cablelength long
Sets the receive sensitivity to 26 dB if you can configure the
hardware's receive sensitivity. This is the default value. However, it is
recommended to enter
value.
Sets the receive sensitivity to 36 dB if you can configure the
hardware's receive sensitivity.
Sets the transmit attenuation to 15 dB.
Sets the transmit attenuation to 22.5 dB.
Controller CLI Commands (X330WAN-2DS1 Only)
context for port 1, vlan 1, with an
so that the CLI entry matches the actual
gain26
form
no
115