Clear Ip Route; Clear Ip Traffic; Default-Metric (Interface Context) - Avaya X330WAN User Manual

Chapter 6 X330WAN CLI Commands

clear ip route

Use the clear ip route command to delete all the dynamic routing entries from
the routing table.
Syntax
clear ip route * | <ip-addr> [<ip-mask>]
ip-addr
ip-mask
Example
clear ip route *
clear ip route 192.168.49.1 255.255.255.0

clear ip traffic

Use the clear ip traffic command to clear the IP counters.
Syntax
clear ip traffic
Example
X330WAN-2DS1-1(super)# clear ip traffic

default-metric (Interface context)

Use the default-metric command to set the interface Routing Information
Protocol (RIP) route metric value. The no form of this command restores the default
value (1).
Note: This command is executed from the Loopback, Serial, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
[no] default-metric <number>
Parameters
number
Example
X330WAN-2DS1-1(configure:interface)#
166
IP address.
IP mask address.
The interface route metric value. The range is 1 to 15.
Clears the entire routing table.
Clears a range of entries.
default-metric 10
Avaya X330WAN User's Guide