Ip Address; Ip Admin-State (Interface Context); Ip Bootp-Dhcp Network (Interface Context) - Avaya X330WAN User Manual

Chapter 6 X330WAN CLI Commands

ip address

Use the ip address command to assign an IP address and mask to an interface.
The form of the command deletes an IP interface.
no
Syntax
[no] ip address <ip-address> <mask> [<admin-state>]
Parameters
ip address
mask
admin-state
Example
To assign the IP address 192.168.22.33 with mask 255.255.255.0 to the Fast Ethernet
interface:
X330WAN-2DS1-1(super-if:FastEthernet1)# ip address 192.168.22.33 24

ip admin-state (Interface context)

Use the ip admin-state command to set the administrative state of an IP
interface. The default state is up.
Syntax
ip admin-state <up/down>
Parameters
up/down

ip bootp-dhcp network (Interface context)

Use the ip bootp-dhcp network command to select the network from which
the BOOTP/DHCP server should allocate an address. This command is required
only when there are multiple IP interfaces over the FabricFastEthernet. The no
form of this command restores the default.
Note: This command is executed from the Fast Ethernet and FabricFastEthernet
interfaces.
170
The IP address assigned to the interface.
Mask for the associated IP subnet.
The administration status, i.e., either up or down (default is up).
This parameter is not applicable for the Console interface of the
X330WAN.
Administrative state of the interface. The choices are Up (active) or
Down (inactive).
Avaya X330WAN User's Guide