Ip Simulate (Interface Context) - Avaya X330WAN User Manual

ip simulate (Interface context)

Use the
command contains the addressed list number and the packet parameters.
Note: This command is executed from the Serial, Loopback, Fast Ethernet, and
FabricFastEthernet interfaces.
Syntax
ip simulate
[<dscp-value>]<source> <destination> [<protocol> [<source
port> <destination port> [<established>]]]
Parameters
policy-list-number
direction
priority
dspc value
source
destination
protocol
source port
destination port
established
Example
X330WAN-2DS1-1(config-if:FastEthernet1)# ip simulate 100 in
192.67.85.12 193.76.54.25
Avaya X330WAN User's Guide
command to check the Policy for a simulated packet. The
ip simulate
<policy-list-number> <direction> [<priority>]
An integer from 100 to 149, where 0 is the default list.
in|out
fwd0|fwd1|..|fwd7
dscp0|dscp1|..|dscp63
Source IP address.
Destination IP address.
ip|tcp|udp|
An integer from 1 to 65535.
An integer from 1 to 65535.
Value of TCP established bit.
Policy CLI Commands
integer from 1 to 255.
217