Configuring E1/T1 Interfaces - Avaya X330WAN User Manual

Chapter 3 Initial Configuration
The primary management interface has changed.
For this change to take effect, you need to copy running-config
startup-config and then reset the device.
Enter the
stage.

Configuring E1/T1 Interfaces

All CLI commands mentioned in this section are described in Chapter 6: X330WAN
CLI Commands.
For a list of X330WAN default settings, see "X330WAN Default Settings" on page 28,
or use the
current settings.
To configure E1 or T1 interfaces:
1 Use the
controller's mode is configured as E1 or T1.
Use the
Changing the line type requires resetting the module.
2 Use the
the port to be configured.
The prompt changes to
where
3 Use the following commands if you want to change the clock source, frame type
and linecode parameters from their default settings:
clock source [line|internal]
framing [sf|esf]
lines.
linecode [ami|b8zs]
cablelength [long|short]
For T1 mode proceed to step 5.
4 Use the
command to specify the channel group and time slots to be mapped. For
example, typing
channel group 1 timeslots 1,3-5,7
and 7 to be mapped in channel-group number 1.
Proceed to step 6.
5 Use the
speed [56|64]
mapped and DS0 speed in kbps. For example, typing
channel group 1 timeslots 1,3-5,7 speed 64
numbered 1, 3-5, and 7 to be mapped in channel-group number 1 and the DS0
speed to 64 kbps.
22
copy running-config startup-config
show controllers <port number>
show controllers <port number>
command to set the controller's mode to E1 or T1.
ds-mode [e1|t1]
controller [e1|t1] <port number>
X330WAN-2DS1-N(super-controller:n)#
is the switch number and
N
for T1 lines or
for T1 lines or
channel-group <channel-number> timeslots <timeslot-list>
channel-group <channel number> timeslots <timeslot list>
command to specify the channel group, time slots to be
and
command to display all of the
command to check if your
command to enter the context of
is the port number.
n
framing [crc4|no-crc4|unframed]
linecode [ami|hdb3]
for T1 lines.
configures time slots numbered 1, 3-5
Avaya X330WAN User's Guide
commands at this
reset
for E1
for E1 lines.
configures time slots