4.4.7 Configuring and Recording Data Example
The following is intended as an example of measuring and recording over a period of 8 hours.
NOTE: Set the instrument's clock to the proper time as the clock may vary due to time zones.
1. If a recording is active, stop it by selecting Instrument > Stop Recording from the main menu.
2. Open the Configure Instrument dialog box (see § 4.4) and select the Recording tab.
3. Select an 8-hour recording duration by selecting the 8 hour option from the Duration drop-down list.
4. Check the Record now checkbox.
At this point the Recording tab should look similar to the figure below.
5. Press OK. This will write the configuration to the instrument and begin a recording (provided enough memory is
available in the instrument).
68
Figure 60
Figure 61
Power & Energy Logger Model PEL 102 and PEL 103