Lcd Display Modes (Pel 103 Only); Base Measurements - Displayed Values - AEMC PEL 102 User Manual

3.7 LCD Display Modes (PEL 103 Only)

The PEL 103 includes an LCD display that allows you to view a variety of measurement values and set-up parameters. The
display also lets you change several configuration settings.
NOTE: Although the PEL 103 LCD display allows you to enter a limited number of set-up values, the PEL can only be
fully configured through the PEL Control Panel (DataView
with the PEL Control Panel. For detailed instructions on configuring, recording and downloading measurements,
refer to § 4.
The ◄ and ► navigation buttons are used to scroll through the available modes LCD Display modes.
Five of these modes allow you to view several types of data:
(Base Measurements) displays the measurement values V, A, Power, Frequency, Power Factor, and Tanget Angle
(Energy) displays the energy values kWk, Vah, and Varh
(Harmonics) displays harmonics for current and voltage
(Max) displays the maximum values for the measurement, energy, and harmonic values
(Information) displays hook-up and system information
In addition:
(Configuration) allows you to enter several setup parameters, described later in this section.

3.7.1 Base Measurements - Displayed Values

The base measurements, or instantaneous readings, are displayed sequentially in screens showing all phases. The display
sequence varies per type of power network. Table 4 shows the readings per network.
To navigate through the displays, use the Navigation
■ Use the up and down arrows (▲ or ▼) on the Navigation button to step through the displays.
■ Use the Enter button to display additional information. Note that this does not advance the display to the next
step. Instead, a screen displayed by Enter can be considered a "sub step" in the display cycle.
■
To exit a display called up by Enter, press the Navigation button once. This returns you to the previous screen;
you can then use ▲ or ▼ to continue navigating through the displays.
■ To exit and move to a different display mode, press ◄ or ► on the Navigation button.
NOTE: In some distribution systems and steps, pressing Enter has no effect.
Power & Energy Logger Model PEL 102 and PEL 103
software). Note that the PEL 102 can only be configured
®
and Enter buttons.
31