Meters Tab Options - AEMC PEL 102 User Manual

4.4.6 Meters Tab Options

The Meters tab of the Configure Instrument dialog box specifies which of the instruments total accumulation meters are
to be reset when the configuration is written to the instrument.
Duration meters:
■
Reset total and partial energy meters: When checked, causes the total energy meters in the instrument to be
reset.
■
Reset duration of power on: When checked, causes the power on meter in the instrument to be reset.
■
Reset duration of voltage presence: When checked, resets the voltage presence meter.
■
Reset duration of current presence: When checked, resets the current presence meter.
■
Energy metering period: Drop-down list containing periods for the instrument energy meters.
Partial Energy Meters:
■
Drop-down list that allows the selection of intervals to be used by the instrument's partial energy accumulators.
The instrument can accumulate the measurements for a group of measurements over a user specified period.
-
Available periods = Selected aggregation period, 1 h, 1 day, 1 week, 1 month.
Total Energy Meters:
-
Reset total energy meters at the start of each new session: When checked, the instrument will reset the
meters when a recording starts (either via software or the instrument's Control button). This allows the energy
meters to represent just the recording period. When not checked, the meters will not reset at the start of each
new recording.
Power & Energy Logger Model PEL 102 and PEL 103
Figure 59
67