Installation Of The Color-Coded Id Markers; Connection Features - AEMC PEL 102 User Manual

For multiple-phase measurements, start by marking the accessories using the color-coded ID markers supplied with the
device; a different color for each current terminal.
Connect the measuring leads to your PEL as follows:
■
Current measurement: I1, I2, I3 4-point connectors
■
Voltage measurement: V1, V2, V3 and N terminals
The measuring leads must be connected to the circuit to be monitored according to the selected hook-up diagram. Do not
forget to define the voltage and current transformer's ratios when necessary.

2.5 Installation of the Color-coded ID Markers

Refer to the current sensor's safety sheet or user manual before connecting it.
Twelve sets of color-coded rings and inserts are supplied with your PEL instrument. Use these ID markers to identify the
leads and input terminals.
■
Detach the appropriate inserts from the color-coded marker and place them in the holes provided under the
terminals (larger inserts for current terminals, smaller inserts for voltage terminals).
■
Clip the rings of the same color to the ends of the lead you will be connecting to the terminal.

2.6 Connection Features

1
Power cord connection (see § 3.5.1).
2
SD card slot (see § 3.5.3).
3
USB connector (see § 3.5.4).
4
Ethernet RJ 45 connector (see § 3.5.5).
Power & Energy Logger Model PEL 102 and PEL 103
1
Figure 4
2 3
Figure 5
4
11