Ethernet Network Connection - AEMC PEL 102 User Manual

4.2.3 Ethernet Network Connection

■
In the Address field, specify the IP address assigned to the PEL.
-
For the PEL103, select the Info icon (
display screen (see § 3.7.5).
-
For the PEL102, a USB or Bluetooth connection will need to be established to determine the IP address
assigned to the instrument.
■
In the Port field, specify the port that the PEL is configured to.
- By default the PEL uses port 3041 (UDP). However, the PEL can be configured to use a different port.
-
The only way to identify the port the PEL is using, is to first communicate with it. So, if the port has been
changed from that of the default, use a USB or Bluetooth connection to identify the port used by the PEL.
NOTE: If you do not know the IP Address and the PEL is located on the same network subnet as the computer, use
the Search button (located to the right of the Address field) to locate the PEL. The search operation (if successful)
will identify the IP address and port used by all the PEL instruments connected on the subnet.
■
Once the IP address and port have been specified, click the Next > button.
■ If a successful connection was established, the Finish button will be enabled. Click Finish to exit the Wizard (see
Figure 44).
■
The instrument will then be added to the PEL Network until it is removed (see § 4.3.4).
52
Figure 46
) on the LCD and use the ▼ button to scroll down to the IP Addr
Power & Energy Logger Model PEL 102 and PEL 103