Recording Data; Starting A Recording Session - AEMC Simple Logger II User Manual

Hide thumbs Also See for Simple Logger II:

Table of Contents

There are two thresholds for the battery voltage:

•

The first is used to indicate low battery. The low battery indicator (Blue

LED single blink) will blink when the battery voltage drops below 2.2V.

The second is used to determine when to terminate recording and

•

turn the unit off. The shutdown threshold is when the battery voltage

drops below 1.7V.

Communication from the instrument to DataView

4.3

Recording Data

The Simple Logger

performed (see the DataView

Once a configuration is written to the instrument, the logger will no longer

need to be connected to DataView

When data is stored in the memory, the user may download the informa-

tion onto a hard-disk.

A scheduled recording will still start even if the logger is in sleep mode.

4.3.1

A new recording cannot be started if the memory is full.

1. Connect the instrument to the measurement source.

2. Make sure the logger is in STANDBY mode.

3. Press and hold the PRESS button. When the START (GREEN) LED

lights up, release the button.

4. The GREEN LED double-blinks every 5 seconds when the logger is

recording.

It may take a few seconds before the instrument starts recording. The

recording status LED will single blink during this period.

Simple Logger

II Series

II must first be configured before a recording can be

Data Logger Control Panel Help).

to start the scheduled recording.

is disabled below 2.2V.

Table of Contents