Emc Compatibility, Shipping And Storage Conditions - Siemens SIMATIC ET 200eco PN Operating Instructions Manual

General technical data

8.2 EMC compatibility, shipping and storage conditions

8.2 EMC compatibility, shipping and storage conditions
Definition
Electromagnetic compatibility is the ability of an electrical device to function in its
electromagnetic environment in a satisfactory manner without affecting this environment.
The ET 200eco PN distributed I/O device also meets the requirements of the EMC law of the
European Single Market. Prerequisite is compliance of the electrical configuration of the
ET 200eco PN distributed I/O device with specifications and directives.
Pulse-shaped disturbances
The table below shows the electromagnetic compatibility of the ET 200eco PN distributed I/O
device with respect to pulse-shaped disturbances.
Electrostatic discharge to
IEC 61000-4-2
Burst pulses (high-speed transi-
ent disturbances) according to
IEC 61000-4-4.
High-energy single pulse (surge) according to IEC 61000-4-5 *
•
•
* On DC 24 V supply only with protective element
Sinusoidal disturbance variables
The table below shows the electromagnetic compatibility of the ET 200eco PN distributed I/O
device with respect to sinusoidal disturbances.
80 to 1000 MHz; 1.4 to 2 GHz
10 V/m 80% AM (1 kHz)
2 to 2.7 GHz
1 V/m at 80 % AM (1 kHz)
102
Pulse-shaped disturbance
Asymmetric coupling
Symmetric coupling
HF radiation according to IEC 61000-4-3
Electromagnetic HF field
Amplitude modulated
Test voltage
8 kV
6 kV
2 kV (power supply line)
2 kV (signal line)
2 kV (power supply line)
2 kV (signal / data line)
1 kV (power supply line)
1 kV (signal / data line)
HF coupling according to
0.15 MHz to 80 MHz
10 V unmodulated
rms
80 % AM (1 kHz)
150 Ω source impedance
Operating Instructions, 08/2016, A5E01250250-AJ
corresponds with degree of
severity
3 (air discharge)
2 (contact discharge)
3
3
3
IEC 61000-4-6
ET 200eco PN