Preface - Siemens SIMATIC ET 200eco PN Operating Instructions Manual

Preface

Purpose of the manual
The information in this manual enables you to operate the ET 200eco PN distributed I/O
device on PROFINET IO as an IO Device.
Basic knowledge required
This manual presumes a general knowledge in the field of automation engineering.
The manual describes the components based on the data valid at the time of its release.
SIEMENS reserves the right of including a product information for each new component, and
for each component of a later version.
Scope of this manual
This manual applies to the ET 200eco PN distributed I/O device.
Changes compared to the previous version
Compared with the previous version, this manual includes the following changes/additions:
● Description of the IO-Link master 4 IO-L 4×M12
● Update of the Standards and Approvals chapter
Standards and certifications
You can find information of which standards and approvals are met by the ET 200eco PN I/O
system in the section Standards and certifications (Page 99).
Scope of information
In addition to this manual, you need:
● The manual for the IO Controller you are using
● The PROFINET System Description
(https://support.industry.siemens.com/cs/ww/en/view/19292127) system manual,
● The From PROFIBUS DP to PROFINET IO
(https://support.industry.siemens.com/cs/ww/en/view/19289930) programming manual.
● The IO-Link System (https://support.industry.siemens.com/cs/ww/en/view/65949252)
function manual.
ET 200eco PN
Operating Instructions, 08/2016, A5E01250250-AJ
3